Instantiate Re6st Access Token

Instantiate Re6st Access Token

How To Instantiate Re6st Access Token

This document explains how to instantiate Re6st Access Tokens which are used to connect new nodes to network maintained by the Re6st Registry of a SlapOS Master.

It will explain the different instantiation parameters. Please refer to other documents on add a software to the SlapOS Master catalog or supplying/installing a software

Table of Content

  • Re6st Token Parameters

Configuring Re6st Access Token

The process of installing (supplying) a software and providing it as a service (instantiation) are the same for all software. However during instantiation each instance can be configured differently.

This section will cover the specific configuration parameters used for a Re6st Access Token, which has to be provided during installation of Re6st on a node.

Token Configuration

SlapOS Interface - Re6st Token Configuration

After adding a new serivce, selecting Re6st and the latest version, you will reach the configuration screen. Set Software Type to Re6st Token. As mentioned, the token is actually a slave instance of the Registry (and in case of COMP-0 a first gateway node).

Select the Computer on which the Registry of your SlapOS Master was installed at the bottom of the page, then click Proceed to instantiate the service and be forwarded to the list of current services. Refresh the page, it may take a few minute for the node to be instantiated and the token to appear. It is a single use token to connect one other node to the network.

You can follow the compilation by looking at the slapos-node-software.log using:

# tail opt/slapos/log/slapos-node-software.log -f

Token Instantiation

SlapOS Interface - Re6st Token Instantiation

Once the token is instantiantiated, click on it to open it's configuration and connection parameters.

Token Connection Parameters

SlapOS Interface - Re6st Token Connection Parameters

Locate the token in the Connection Parameters. It might require a few minutes to show up.

With the Registry token, you can now install Re6st on a fresh node.

Thank You

Image Nexedi Office
  • Nexedi SA
  • 147 Rue du Ballon
  • 59110 La Madeleine
  • France